P&S – Triple S All-In-One Wrap Install Solution

TRIPLE S is the ultimate all-in-one solution designed to support every stage of the vehicle wrapping process.

Built for commercial wraps, color change films, and PPF, this innovative formula simplifies prep, installation, and post install care while delivering a finish that both installers and customers will appreciate.

• SLIP – For PREP, wiping the surface down with TRIPLE S eliminates sanding and adhesive lines while allowing even the most difficult films to slide easily across the surface
• SLIDE – During the INSTALL, spraying TRIPLE S on the squeegee buffer enables it to slide effortlessly and scratch-free across the wrap film
• SHINE – For POST-INSTALL, wiping the wrap down with TRIPLE S enhances the wrap while leaving a protective finish that lasts and lasts

Developed by P&S Detail Products for The Rag Company and designed to meet the standards of The Wrap Institute, this unique formula uses advanced polymer technology to reduce surface energy, improve workflow efficiency, and maintain the quality of wrapped surfaces. It also provides enhanced UV protection to help prevent fading while leaving behind a refreshing watermelon lemonade scent.

Why You’ll Love It:

• One product supports the entire wrap workflow from prep to aftercare
• Helps installers work faster with smoother film movement
• Reduces installation fatigue by improving tool glide
• Enhances both gloss and matte wrap finishes
• Helps keep wraps looking vibrant and well maintained
• Leaves a refreshing watermelon lemonade scent during use

How to use

Prep – SLIP

• Clean, clay and degrease the vehicle.
• Generously spray Triple S on the section to be installed and polish it evenly across the surface with a TRC Edgeless 365 microfibre towel.
• Wipe Triple S off the outside edges and any recessed areas with a 70% IPA solution (roughly 1″ wide). This will help ensure maximum adhesion on these key durability areas.
• Allow Triple S to dry completely (10-15 seconds) then move to install.

Install – SLIDE

• Spray the squeegee buffer thoroughly on both sides with Triple S (prep squeegee in a safe area to avoid slipping or over spray).
• Squeegee the wrapping film in a standard manner.
• Re-apply Triple S to the squeegee as needed during the install.
• Once the panel is applied, move to the Post Install protocol.

Post Install – SHINE

• Spray the wrapped section with Triple S as soon as the install is completed.
• For best results, use a TRC Premium Pearl microfiber towel.
• Spread and buff Triple S evenly across the surface to ensure full coverage and protection.